Print Page - MyVision X: How do I change the horizontal offset for inkjet endorsing an item?

Title: MyVision X: How do I change the horizontal offset for inkjet endorsing an item?
Post by: Bryan Clark on April 21, 2008, 12:59:55 PM

On the MyVision X, how do I change the horizontal offset for endorsing an item?

Do you have a INI setting?

Title: Re: MyVision X: How do I change the horizontal offset for endorsing an item?
Post by: Bryan Clark on April 21, 2008, 01:03:48 PM

You can set the offset by changing an ini value in the driver options file (MVXOptions.ini). The ini setting is in the "Inkjet" section and is called "EndorsementOffset." valid range of values is 0-180 mm.

Silver Bullet - Support Forum

Ranger => Panini Check Scanners => Topic started by: Bryan Clark on April 21, 2008, 12:59:55 PM