We are just adding support for the CX30. Here are some temporary instructions for installing one now.
1. Unplug the scanner
2. Install Ranger
3. Connect the scanner power supply and USB cables into the ports on the bottom and route them through one of the channels.
4. Connect the power supply into a power outlet and the USB cable into one of the USB ports on the PC. Note, the scanner will not indicate power unless the USB cable is plugged into the PC.
5. The multi-function LED should show RED.
6. Launch your application and select it to scan an item. The LED should turn Green.
7. Note, if your application fails to turn the LED green, press and release the reset button below the LED and wait to see if the application will acquire the scanner. If it still fails, contact Silver Bullet Support.